Chimney Company in Four Corners - One Flat Price, You See What We See

Chimney Company in Four Corners, TX

Most chimney calls we take in Four Corners aren’t about smoke pouring into a living room. They’re about water. Flues in this part of Houston sit dormant through long humid months, and when a cap cracks or a crown goes soft, the damage happens quietly behind the brick. That’s why chimney repair is the work we do most here, and why we start with a camera look at the flue before recommending anything. Our technicians have up to 9 years of experience with the factory-built and masonry fireplaces common to Four Corners homes. Call (866) 809-2352 to book an inspection.

Call (866) 809-2352

Why Four Corners Homes Are Different

Four Corners sits along the Bellaire Blvd corridor near the 77083 ZIP, in the middle of Houston’s southwest Asian and South Asian community. That shapes chimney work in ways a generic suburb doesn’t. Many homes here are owner-occupied, families stay put for years, and the fireplace gets used in patterns tied to household cooking and heating routines rather than the “light it a few times at Christmas” habit you see elsewhere. When a fireplace actually earns its keep, creosote accumulates on a real schedule, not a hypothetical one.

The housing stock matters just as much. Much of 77083 was built in the late 1990s and 2000s: brick-veneer tract and semi-custom homes in master-planned subdivisions, many with factory-built or masonry wood-burning fireplaces. Some newer builds went gas-only, and those need vent inspection rather than a traditional sweep. Gulf humidity does the rest. Moisture intrusion, cap and crown deterioration, and animal or insect nesting in dormant flues are the problems we find most, with a burst of calls during the brief December through February cold fronts.

Our Main Four Corners Services

Two jobs account for most of what Four Corners homeowners ask us about: getting the flue clean and safe, and getting the dryer vent cleared out.

Chimney Sweep in Four Corners

A sweep here usually means more than brushing soot. Because flues in Four Corners sit idle through humid Gulf months, we run a camera through the flue to check for nesting debris, cracked tiles, and moisture damage before we clean. The sweep itself removes creosote and whatever a squirrel or bird left behind, then we show you the photo record so you know what the inside of your chimney actually looks like. It’s the single best way to know whether your fireplace is ready for the first cold front. Book a chimney sweep before the season turns.

Dryer Vent Cleaning in Four Corners

Lint packed into a dryer duct is one of the leading causes of residential house fires, and in Four Corners homes where the laundry room sits far from an exterior wall, the run is often long and full of elbows where lint collects. We pull the duct apart, clear the whole line, and check that the exterior damper opens freely. It pairs naturally with a chimney visit since both are combustion-related hazards in the same house. Schedule dryer vent cleaning alongside your sweep and we handle both in one trip.

Chimney Repair in Four Corners

Chimney repair in Four Corners is mostly a moisture story. The late-1990s and 2000s brick-veneer homes throughout 77083 were built with caps and crowns that have now had twenty-plus Gulf summers of sun and rain, and the factory-built fireplaces inside many of them went years without anyone looking up. Add a flue that stays dormant through humid months and you get rusted chase tops, crumbling mortar, and water finding its way into the firebox. Our Chimney Repair work starts with a camera inspection and ends with the fix, whether that’s a new cap, a poured crown, or a liner. Repairs happen under one call rather than getting handed off to a separate masonry contractor.

Chimney Cap Installation

Signs you need it

You’re missing a cap entirely, or the one you have is a thin sheet-metal style that’s rusted through and letting rain and animals straight down the flue.

What it costs in Four Corners

Chimney cap installation in Four Corners typically runs $150 to $400, depending on flue size and whether a custom footprint is needed for a factory-built chase.

How we do it

We measure the flue opening, fit a stainless or copper cap sized to the exact footprint, and fasten it to the chase or crown so wind off the coastal plain can’t shift it.

Chimney Cap Replacement

Signs you need it

The existing cap is loose, bent, rusted at the seams, or a storm has knocked it crooked enough that water runs in around one edge.

What it costs in Four Corners

Replacing a failed cap in Four Corners typically falls between $175 and $450, with multi-flue chases at the higher end.

How we do it

We remove the old cap and its fasteners, inspect the chase top for rust-through while it’s exposed, then set a new cap with fresh stainless hardware and seal the perimeter.

Chimney Liner Installation

Signs you need it

The camera shows cracked or missing clay tiles, a rusted factory-built liner, or gaps at the joints that let heat reach framing.

What it costs in Four Corners

Liner installation in Four Corners typically starts around $2,500 and can reach $6,000 or more for a long or offset flue that needs a flexible system.

How we do it

We run a DuraFlex flexible liner sized to the appliance, which handles the offset and irregular flues common in these subdivisions where rigid pipe won’t pass, then insulate and connect it top and bottom. This is not a job to attempt yourself; a liner that isn’t correctly sized or sealed can let combustion gases into the home.

Chimney Flashing Repair

Signs you need it

You see rust streaks or a dark water stain on the ceiling near the chimney, or the metal where the chimney meets the roof has pulled away from the shingles.

What it costs in Four Corners

Flashing repair in Four Corners typically runs $300 to $700, with full flashing replacement at the top of that range.

How we do it

We lift the surrounding shingles, reset the flashing into the mortar joint or chase, seal the step and apron sections, and confirm the joint sheds water away from the chimney rather than into it.

Chimney Crown Repair

Signs you need it

The concrete top of the chimney is cracked, spalling, or pulling away from the flue, which is the most common way water gets into a Four Corners chimney.

What it costs in Four Corners

Crown repair in Four Corners typically costs $300 to $800, and a full crown rebuild sits at the higher end.

How we do it

We chip out the failed concrete, form a new crown with the correct slope away from the flue, and seal the bond at the flue so runoff leaves the chimney instead of soaking into the brick.

What Chimney Repair Costs in Four Corners

Do I really need a new liner, or is that an upsell?

You need a new liner only when the camera shows cracked tiles, a rusted factory liner, or gaps that let heat reach framing. We show you the footage before recommending anything, and if a HeatShield ceramic resurfacing can restore the flue without a full reliner, we’ll tell you that instead. It costs less and works when the damage isn’t structural.

Can chimney repair in Four Corners wait until spring?

Some of it can, and we’ll say so plainly. Crown and cap problems should be fixed before the rainy season since water damage compounds. Cosmetic mortar work can usually wait. Nothing gets recommended without camera evidence you can see for yourself.

Brands We Service in Four Corners

We work with professional-grade product lines rather than big-box materials: DuraFlex flexible liner systems for retrofits, HeatShield ceramic resurfacing, Gelco, Olympia Chimney, Famco, and Copperfield. If your chimney carries one of these, we can service it, and we’re HeatShield-certified for flue resurfacing. Turnaround depends on whether parts need ordering, and the written estimate tells you before we start. See our brands for the full list.

Pricing for Chimney Company in Four Corners, TX

Neighborhoods We Serve in Four Corners

We work throughout the Four Corners community along Bellaire Blvd and the surrounding streets in the 77083 ZIP, including the master-planned subdivisions where most of the local brick-veneer housing sits. Because the neighborhoods here sit close together and just off the Bellaire corridor, one response window covers the whole area rather than varying block by block. When you call, we’ll confirm the next opening and get you on the schedule.

• Four Corners along Bellaire Blvd
• Subdivisions off the 77083 corridor
• Homes near the Mission Bend border
• Streets south toward the Pecan Grove side

Service Area – Cities Near Four Corners

Four Corners sits in a dense stretch of southwest Houston, and we cover the cities around it. If you’re just outside the Four Corners neighborhood line, you’re still in range: we also work in Mission Bend, TX, Meadows Place, TX, Pecan Grove, TX, and Sugar Land, TX. The same humid-climate chimney and vent problems show up across all of them, so the inspection and repair approach carries over. Call and we’ll confirm coverage for your address.

FAQs About Chimney Company in Four Corners